A Method for Calculating The Values of Forces Acting on The Roller-cone Bit Teeth
Vladimir Alekseevich Pyalchenkov1, Vladimir Veniaminovich Dolgushin2, Gennadiy Andreevich Kulyabin3, Dmitry Vladimirovich Pyalchenkov4
1Vladimir Alekseevich Pyalchenkov*, Tyumen Industrial University, Transportation Institute, Tyumen, Russia.
2Vladimir Veniaminovich Dolgushin, Tyumen Industrial University, Institute of Industrial Technology and Engineering, Tyumen, Russia.
3Gennadiy Andreevich Kulyabin, Tyumen Industrial University, Institute of Geology and oil and Gas Production, Tyumen, Russia.
4Dmitry Vladimirovich Pyalchenkov, Tyumen Industrial University, Institute of Service Management and Industry, Tyumen, Russia.
Manuscript received on September 18, 2019. | Revised Manuscript received on October 15, 2019. | Manuscript published on October 30, 2019. | PP: 834-839 | Volume-9 Issue-1, October 2019 | Retrieval Number: A9381109119/2019©BEIESP | DOI: 10.35940/ijeat.A9381.109119
Open Access | Ethics and Policies | Cite | Mendeley
© The Authors. Blue Eyes Intelligence Engineering and Sciences Publication (BEIESP). This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/)
Abstract: The results of an analytical study of the loading of elements of a roller-cone bit cutting structure are given. For an analytical assessment of the magnitude of the forces acting on the bit teeth, the bit is fixed in a static state in a string of drill pipes or a drill assembly, with each roller cone resting on a flat bottom with one tooth on which axial force acts from the bottom. For the disclosure of static indefinability, the equations of deformation of the system are compiled. Calculation of the loads acting on the cone rows was carried out in relation to the cutting structure layout for the Sh215,9K-PV bit cones. To determine the values of the forces acting on the teeth, the dependencies between the magnitude of the load acting on the roller cone and the vertical movement of this tooth, previously obtained analytically and experimentally, were used. It is established that the maximum load acts on the rows located in the middle part of the bit radius. The calculation results are confirmed experimentally. The results obtained can be used to optimize the design of the cutting structures and supports of roller-cone bits at the design stage.
Keywords: Bit, Cone cutting structure, Drilling, Load, Roller cone, Support.