Stability of Physically-Loaded Helical Springs used In Smart Fork Lift
Suresh Kumar1, M.L. Aggarwal2, Lakhwinder Singh3

1Suresh Kumar, PhD Student, Department of Mechanical Engineering, YMCA University of Science & Technology, Faridabad, Haryana, India.
2M.L. Aggarwal, Professor, Department of Mechanical Engineering, YMCA University of Science &Technology, Faridabad, Haryana, India.
3Lakhwinder Singh, Professor, Department of Mechanical Engineering, YMCA University of Science & Technology, Faridabad, Haryana, India.
Manuscript received on November 21, 2019. | Revised Manuscript received on December 15, 2019. | Manuscript published on December 30, 2019. | PP: 3839-3845  | Volume-9 Issue-2, December, 2019. | Retrieval Number:  B4424129219/2019©BEIESP | DOI: 10.35940/ijeat.B4424.129219
Open Access | Ethics and Policies | Cite | Mendeley
© The Authors. Blue Eyes Intelligence Engineering and Sciences Publication (BEIESP). This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/)

Abstract: In the following section, the behavior of helical compression springs is considered in smart fork lift (established in previous work). We have used commonly used cylindrical and conical shape helical spring as storage devices in which stability defined in term of load-gains, deflections and evaluation of spring-rates. Springs’ rates of both springs were compared on a common platform. Initially both springs (helical-conical) was prepared from the coiled wires. These prepared springs also known as coil springs which regain its original form and position when distorted by the loaded in smart fork-lift apparatus. These coils springs here developed by the applying the heat treatment and quenching processes on the galvanized spring steel material by using the threaded shape fixtures. This prescribed work focused on effect of physically-loaded gains by cylindrical and conical shaped helical spring in smart fork lift. Here, springs worked as mechanical devices to bear the lifting load which differed here greatly in strength and in size depending on changing its parameters. Both the cylindrical and conical shape was made of helically coiled wires with constant clearance between the active coils and able to absorbed external counteracting loads applied against each other in their axis. One direction deformation in axially format was considered.
Keywords: Heat treatment, Helical-conical springs, Quenching process, Spring –rate, Smart fork lift.