An Experimental Assessment on the Impact of Injection Pressure on the Characteristics of a Diesel Engine Powered with the Blend of Diesel and Microalgae Biodiesel
Nambaya Charyulu Tatikonda1, P. Naveenchandran2

1Nambaya Charyulu Tatikonda*, Department of Mechanical Engineering, SVIST, Tiruvuru, A.P, India. Research Scholar, Mech. Engg. Dept. BIHER (Bharath University), Chennai, India.
2Dr. P. Naveen chandran, Automobile Engineering Department, BIHER (Bharath University), Chennai, India.
Manuscript received on July 20, 2019. | Revised Manuscript received on August 10, 2019. | Manuscript published on August 30, 2019. | PP: 3284-3291 | Volume-8 Issue-6, August 2019. | Retrieval Number: F9500088619/2019©BEIESP | DOI: 10.35940/ijeat.F9500.088619
Open Access | Ethics and Policies | Cite | Mendeley
© The Authors. Blue Eyes Intelligence Engineering and Sciences Publication (BEIESP). This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/)

Abstract: Microalgae was recognized as the sustainable energy feedstock for producing biofuels. Now bio-diesel produced from algal biomass is getting ready to address the energy crisis that the world would face tomorrow. This paper deals with the utilization of microalgae biodiesel at 30% blend, to investigate the influence of operating parameter such as injection pressure on the characteristics of a compression ignition engine. Microalgae crude oil was derived from chlorella vulgaries and it was converted into microalgae methyl ester (MME) using transesterification process. The desired test fuel was prepared by mixing of 30% MME with 70% pure diesel and designated as B30. The experiment was conducted on single cylinder four stroke diesel engine powered with B30 at various fuel injection pressures in the range of 180 bar, 200 bar and 220 bar. The experimental results showed that, no significant impact of modified injection pressures on BSFC, whereas BTE was increased maximum by 14.09% at 200 bar. The exhaust emissions such as CO, CO2 , UHC and smoke opacity were improved mostly at 200 bar injection pressure, but NOX emission was increased, and increment in cylinder peak pressure was discovered only at 200 bar.
Keywords: Sustainable energy, Chlorella Vulgaries, Microalgae crude oil, Microalgae methyl ester, Transesterification