Experimental & Mathematical Modeling and Analysis of Piezoelectric Energy Harvesting With Dynamic Periodic Loading
Mohit Yadav1, Dinesh Yadav2, Surendra Kumar3, Ramesh Kumar Garg4, Deepak Chhabra5
1Mohit Yadav, Department of Applied Sciences, University Institute of Engineering & Technology, Maharshi Dayanand University Rohtak India.
2Dinesh Yadav, Department of Mechanical Engineering, Deenbandhu Chhotu Ram University, Murthal, India.
3Dr. Surendra Kumar, Department of Applied Sciences, University Institute of Engineering & Technology, Maharshi Dayanand University Rohtak India.
4Dr. Ramesh Kumar Garg, Department of Mechanical Engineering, Deenbandhu Chhotu Ram University, Murthal, India.
5Dr. Deepak Chhabra, Department of Mechanical Engineering, University Institute of Engineering & Technology, Maharshi Dayanand University Rohtak, India.
Manuscript received on 19 August 2019. | Revised Manuscript received on 24 August 2019. | Manuscript published on 30 September 2019. | PP: 6346-6350 | Volume-8 Issue-3 September 2019 | Retrieval Number: C6107098319/19©BEIESP | DOI: 10.35940/ijrte.C6107.098319
Open Access | Ethics and Policies | Cite | Mendeley | Indexing and Abstracting
© The Authors. Blue Eyes Intelligence Engineering and Sciences Publication (BEIESP). This is an open access article under the CC-BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/)
Abstract: In this research work, an experimental model is developed to apply the dynamic periodic load on piezoelectric material for energy harvesting. The proposed setup is analyzed to calculate the energy harvested with circular piezo-patch with end supported boundary conditions. Piezo patch is connected with full bridge rectifier circuit under dynamic loading condition to calculate the output of the system. The proposed setup consists of a force sensor, a printed circuit board (P.C.B.) with calibration circuit, a LCD display unit, a stepper motor, a suitable power source and a robust mechanism to apply the dynamic periodic load. The input dynamic load can be varied by varying the height of the piezo-patch. Mathematical modeling of the proposed system has also been developed and successfully validated with experimental results. It is observed that the proposed setup and mathematical modeling accurately apply varying dynamic load and able to calculate the output of the system.
Keywords: Experimental Setup, Mathematical Modeling, PCB, Force Sensor
Scope of the Article: Software Domain Modelling and Analysis