MRR – Performance on EDM Drilling over Nano Composite Material
S.Dhandapani1, T.Rajmohan2, D.Kumar3
1S.Dhandapani, Mechanical Engg Dept, Rajalakshmi Engineering College, Thandalam, Chennai (Tamil Nadu), India.
2T.Rajmohan Mechanical Engg Dept Faculty of Engg & Tech, SCSVMV University, Kanchipuram, TN, India.
3D.Kumar, Mechanical Engg Dept, Arjun Colege of Engg & Technology, Coimbatore, TN, India.

Manuscript received on November 17., 2019. | Revised Manuscript received on November 24 2019. | Manuscript published on 30 November, 2019. | PP: 12340-12345 | Volume-8 Issue-4, November 2019. | Retrieval Number: D9475118419/2019©BEIESP | DOI: 10.35940/ijrte.D9475.118419

Open Access | Ethics and Policies | Cite  | Mendeley | Indexing and Abstracting
© The Authors. Blue Eyes Intelligence Engineering and Sciences Publication (BEIESP). This is an open access article under the CC-BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/)

Abstract: Now a day’s more research works are going on performance of MRR on various operations with respect to EDM machining. This research paper is to focus the same on parameters base with Performance measure of Material Removal Rate (MRR) in composite Material (Aluminum, Boron Carbide and Multi Wall Carbon NanoTubes (MWCNT) .The machine used for this research is Sink EDM with drilling operation. .Lots of statistical techniques are available to predict the accurate and reliable result form the research data. Here the Minitab 16 software is used to analyze the MRR performance. The input parameters selected for the EDM machine are: Pulse on time, pulse off time and voltage. The results were compared with the DOE-Taguchi approach (L9) Orthogonal array – result. [1] .Material Removal Rate was studied along with S/N ratio of Main effect plot, Means and Interaction Plot.[2] From software the main effect plots, residual plots, S/N ratio interaction plots and means was obtained The rapid increase with pulse on for MRR is resulted due to addition of nano powder and linearly increase with peak current. The optimal parameters combination was determined as CNT (1%), Pulse on (10 μs), Pulse off (2.5 μs) and Peak Current (50A) i.e. 1 4 4 2. The experimental results were checked with predicted results and a positive agreement was found. Comparing old studies the optimization values found by this experiment results with more MRR. Keywords:
Keywords: Nano Composite Materials, EDM, Taguchi Method, MRR & Minitab16 Software.
Scope of the Article: Software Engineering & Its Applications.