Abstract
Leaky guided modes propagating along embedded fibers in a composite material can be used for characterizing the fiber-matrix interface. This principle can be applied to real composites containing small-diameter fibers by using laser interferometric detection of very fine lateral resolution on the order of a few microns. The main purpose of this paper is to develop the analytical tools needed to assess the sensitivity of guided wave inspection to interface properties in composite materials. Typically, the sound velocity is much lower in the matrix than in the fiber and the guided modes are strongly attenuated by leaking their energy into the matrix as they propagate. As a result, the velocity of the lowest-order axisymmetric longitudinal mode decreases while its attenuation increases with increasing interfacial stiffness between the fiber and the matrix. It is shown that loose fibers can be readily identified from early signals produced by fast guided modes. In the case of a well-bonded fiber-matrix interface, these guided modes are slowed down and strongly attenuated by the loading of the matrix depending on the fiber diameter and the interfacial stiffness of the interface. Interestingly, the relative difference between the well-bonded and free fibers is greater at low frequencies. Therefore, good sensitivity to the sought interfacial stiffness can be achieved at a few MHz, i.e., when the fiber diameter is still much smaller than the acoustic wavelength. Our analytical results show that the leaky guided mode technique is mainly sensitive to the transverse interfacial stiffness of the fiber-matrix interface. At typical ultrasonic frequencies between 1 and 20 MHz, the technique works best in the 1011–1013 N/m3 interfacial stiffness range which is one or two orders of magnitude lower than the optimal sensitivity range of the more conventional bulk velocity and reflection methods.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Y. C. Chu and S. I. Rokhlin, Determination of macro- and micromechanical and interfacial elastic properties of composites from ultrasonic data,J. Acoust. Soc. Am. 92:920–931 (1992).
R. C. Addison, Jr. and A. N. Sinclair, Calculated and measured response of an elastic cylinder embedded in an elastic medium, inReview of Progress in Quantitative NDE, Vol. 11A, D. O. Thompson and D. E. Chimenti, eds. (Plenum Press, New York, 1992), pp. 105–111.
A. N. Sinclair and R. C. Addison, Jr., Acoustic diffraction spectrum of a SiC fiber in a solid elastic medium,J. Acoust. Soc. Am. 94:1126–1135 (1993).
T. E. Matikas and P. Karpur, Ultrasonic reflectivity technique for the characterization of fiber-matrix interface in metal matrix composites,J. Appl. Phys. 74:228–236 (1993).
E. Drescher-Krasicka, J. A. Simmons, and H. N. G. Wadley, Guided interface waves, inReview of Progress in Quantitative NDE, Vol. 6B, D. O. Thompson and D. E. Chimenti, eds. (Plenum Press, New York, 1987), pp. 1129–1136.
J. A. Simmons, E. Drescher-Krasicka, H. N. G. Wadley, M. Rosen, and T. M. Hsieh, Ultrasonic methods for characterizing the interface in composites, inReview of Progress in Quantitative NDE, Vol. 7D, D. O. Thompson and D. E. Chimenti, eds. (Plenum Press, New York, 1988), pp. 893–901.
E. Drescher-Krasicka, J. A. Simmons, and H. N. G. Wadley, Fast leaky modes on cylindrical metal-ceramic interfaces, inReview of Progress in Quantitative NDE, Vol. 9A, D. O. Thompson and D. E. Chimenti, eds. (Plenum Press, New York, 1990), pp. 173–179.
J. A. Simmons, E. Drescher-Krasicka, and H. N. G. Wadley, Leaky symmetric modes in infinite clad rods,J. Acoust. Soc. Am. 92:1061–1090 (1992).
P. C. Xu and S. K. Datta, Characterization of fiber-matrix interface by guided waves: Axisymmetric case,J. Acoust. Soc. Am. 89:2573–2583 (1991).
C. H. Yew and P. N. Jogi, A study of wave motion in fiber-reinforced medium,Int. J. Solids Struct. 12:693–703 (1976).
W. R. Scott, M. J. Ryan, and D. M. Granata, Imaging surface displacement of a piezoelectric composite, inReview of Progress in Quantitative NDE, Vol. 12A, D. O. Thompson and D. E. Chimenti, eds. (Plenum Press, New York, 1993), pp. 965–971.
M. deBilly, P. B. Nagy, G. Blaho, S. Meng, G. Quentin, and L. Adler, Experimental investigation of ultrasonic vibrations of thin fibers embedded in matrix, inReview of Progress in Quantitative NDE, Vol. 12B, D. O. Thompson and D. E. Chimenti, eds. (Plenum Press, New York, 1993), pp. 1499–1506.
R. N. Thurston, Elastic waves in rods and clad rods,J. Acoust. Soc. Am. 64:1–37 (1978).
J. P. Jones and J. S. Whittier, Waves in a flexibly bonded interface,J. Appl. Mech. 34:905–909 (1967).
H. G. Tattershall, The ultrasonic pulse-echo technique as applied to adhesion testing,J. Phys. D, Appl. Phys. 6:819–832 (1973).
M. Schoenberg, Elastic wave behavior across linear slip interfaces,J. Acoust. Soc. Am. 68:1516–1521 (1980).
P. B. Nagy, G. Blaho, and L. Adler, Fiber-matrix interface characterization by leaky guided waves propagation along the fibers, inReview of Progress in Quantitative NDE, Vol. 13B, D. O. Thompson and D. E. Chimenti, eds. (Plenum Press, New York, 1994), pp. 1437–1444.
In Ref. 8 one element of the boundary condition matrix is misprinted. In Eq. 5,a 12 should not have the pre-factor 2.
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Nagy, P.B. Leaky guided wave propagation along imperfectly bonded fibers in composite materials. J Nondestruct Eval 13, 137–145 (1994). https://doi.org/10.1007/BF00728251
Received:
Revised:
Issue Date:
DOI: https://doi.org/10.1007/BF00728251