Melting kinetics of a plagioclase feldspar

Abstract

Partial melting experiments on plagioclase feldspar have been carried out to investigate textures and kinetics of the melting. A labradorite single crystal was heated at one atmosphere pressure and temperatures within its melting interval as a function of time. So called honeycomb, fingerprint, or sieve textures were produced except for the runs just below the liquidus. The melting was initiated by heterogeneous nucleation of melt at the surface and/or interior (cracks and possively dislocations) of the crystal. The pattern of the melt is dendritic with a few μm arm spacing. After the melt develops throughout the crystal, the volumes of melt and residual crystal become larger and smaller, respectively, without changing the arm spacings. The melt is homogeneous and has the approximate temperature dependent liquidus composition irrespective of the time. There are compositional gradients in the residual crystal after short periods of melting. The An content of the crystals increases with increasing time until it finally reaches equilibrium with the melt after several thousands minutes of heating. It is concluded that the enlargement of the melt, the main process of the melting, is controlled by diffusion in the crystal. The fact that partial melts have the composition of the equilibrium liquidus even from the first several minutes strongly suggests that the local equilibrium at the crystal-liquid interface is satisfied during the melting. Some of the honeycomb, fingerprint, and sieve textures found in xenoliths and phenocrysts of sodic plagioclase in volcanic rocks would be caused by heating events (such as magma mixing) during which temperatures of magmas were temporarily higher than the solidus of some of the minerals.