Abstract
We derived equations that relate the length of a plastic zone near a mode I crack tip in a plate made of an orthotropic material with yield strength levels in the direction of the anisotropy axes. The case of crack orientation along one of the anisotropy axes is examined, with the latter being determined by the strain hardening of a material at the stage preceding the crack nucleation. The growth of yield strength along the axes lying in the plane of the plate is shown to result in smaller sizes of the plastic zone. An increase in yield strength in the direction of the normal to the above plane leads to an increase in its length.
Similar content being viewed by others
References
D. Broek,Elementary Engineering Fracture Mechanics, Noordhoff International Publishing, Leyden (1974).
P. G. Miklyaev and Ya. B. Fridman,Anisotropy of the Mechanical Properties of Materials [in Russian], Metallurgiya, Moscow (1969).
V. N. Bastun and N. I. Chernyak, “Effect of stress and strain states on the elastic modulus of steels,”Probl. Prochn., No. 9, 52–55 (1971).
V. N. Bastun, “Plastic zone near the crack tip in a material with strain anisotropy caused by loading along spatial rectilinear trajectories,”Probl. Prochn., No. 6, 21–27 (1997).
A. A. Ilyushin,Plasticity. Fundamentals of a General Mathematical Theory [in Russian], Izd. AN SSSR, Moscow (1963).
V. N. Bastun, “Plasticity condition of anisotropic bodies,”Prikl. Mekh.,13, No. 1, 104–109 (1977).
Additional information
Ukrainian Regional Research and Design Institute of Civil Engineering, Kiev, Ukraine. Translated from Problemy Prochnosti, No. 4, pp. 32–37, July–August, 1999.
Rights and permissions
About this article
Cite this article
Bastun, V.N. Correlation of a plastic zone length near the tip of a mode I crack in an orthotropic material with anisotropy parameters. Strength Mater 31, 351–355 (1999). https://doi.org/10.1007/BF02511133
Received:
Issue Date:
DOI: https://doi.org/10.1007/BF02511133