Abstract.
Femtosecond laser ablation of metallic bulk crystals of Au, Ag and Cu was experimentally studied with laser pulse widths ranging from 120 fs through 800 fs at a center wavelength of 780 nm for micro-machining applications. Two different ablation regimes were found in terms of the laser fluence. The characteristic length of different ablation regimes was explained in terms of the optical skin depth and thermal diffusion length; it was determined by the peak electron temperature in the two-temperature model. The lateral feature of the two ablation regimes is discriminated by the amount of particles accumulated by the evaporation process. Ablated particle was observed less in the lower fluence regime than in the higher fluence regime, but there was no significant difference on the ablated surface. The parameters used in the two-temperature model, are discussed in order to model the ultrashort pulsed laser ablation process theoretically. It is shown that the obtainable range of the lower fluence regime is enhanced with the shorter pulse lasers, because the ablation etch rate is decreased with longer pulse width.
Similar content being viewed by others
Author information
Authors and Affiliations
Additional information
Received: 23 August 1999 / Accepted: 13 September 1999 / Published online: 28 December 1999
Rights and permissions
About this article
Cite this article
Furusawa, K., Takahashi, K., Kumagai, H. et al. Ablation characteristics of Au, Ag, and Cu metals using a femtosecond Ti:sapphire laser . Appl Phys A 69 (Suppl 1), S359–S366 (1999). https://doi.org/10.1007/s003390051417
Issue Date:
DOI: https://doi.org/10.1007/s003390051417