Abstract
The safety and stability of roadways is greatly influenced by the complex geological conditions present in the Sanmenxia Bauxite Mine, Henan Province, China. In this study, based on data from field survey, advanced detection methods, numerical studies, and monitoring studies, we have adopted the method of steel fiber-reinforced shotcrete to improve the excavation rate of roadways and guarantee the safety of the tunnel when it passes through unfavorable geological bodies, such as shale rocks and broken argillaceous limestone. Field surveys showed that the stability of roof rocks is the major problem faced by engineers; however, tunnel construction using cast-in-situ concrete, which is the method currently applied, costs too much time, resulting in an excavation rate that is too slow to meet the requirements of the Sanmenxia Bauxite Mine. Here, we propose an optimized scheme which, when combined with numerical simulations and data from advanced detection techniques and field monitoring surveys, can improve the efficiency of roadway roof support. During the implementation of the new scheme, the geological anomalies ahead of the working face were detected in advance. It is assumed that the supporting effect of the steel fiber-reinforced shotcrete is equivalent to that of the cast-in-situ concrete as long as a certain thickness is reached. Moreover, the steel fiber-reinforced shotcrete has better mechanical properties than cast-in-situ concrete and achieves a better combination effect with surrounding rock masses. Based on geological conditions and numerical results, the shotcrete should be thickest in the middle area along the roadway axis passing through the unfavorable geological bodies, and gradually become less thick from the middle to both ends. Field tests were carried out to verify the effectiveness of the scheme. The monitoring results show that the roadway passing through broken argillaceous limestone was stable after being supported by shotcrete (at least 80 mm); its thickness should reach at least about 120 mm when passing through shale rock mass. The results indicate that the use of steel fiber-reinforced shotcrete can considerably shorten the construction time compared with cast-in-situ concrete support. The scheme has proved to be a feasible, economical, and time-saving method for underground excavation in the Sanmenxia Bauxite Mine.
Similar content being viewed by others
References
Bae B, Chung J, Choi H, Jung H, Choi C (2018) Experimental study on the cyclic behavior of steel fiber reinforced high strength concrete columns and evaluation of shear strength. Eng Struct 157:250–267
Coggan J, Gao F, Stead D, Elmo D (2012) Numerical modelling of the effects of weak immediate roof lithology on coal mine roadway stability. Int J Coal Geol 90:100–109
Fabre G, Pellet F (2006) Creep and time-dependent damage in argillaceous rocks. Int J Rock Mech Min Sci 43(6):950–960
Guo WB, Wang HS, Dong GW, Li L, Huang YG (2017) A case study of effective support working resistance and roof support technology in thick seam fully-mechanized face mining with hard roof conditions. Sustain Basel 9(6):935
Guo Z, Yang X, Bai Y, Zhou F, Li E, Guo Z, Yang X, Bai Y, Zhou F, Li E (2012) A study of support strategies in deep soft rock: the horsehead crossing roadway in Daqiang coal mine. Int J Min Sci Technol 22(5):665–667
Jin L, Song W, Shu X, Huang B (2018) Use of water reducer to enhance the mechanical and durability properties of cement-treated soil. Constr Build Mater 159:690–694
Jovicic V, Sustersic J, Vukelic Z (2009) The application of fibre reinforced shotcrete as primary support for a tunnel in flysch. Tunn Undergr Space Technol 24(6):723–730
Kaiser PK, Cai M (2012) Design of rock support system under rockburst condition. J Rock Mech Geotech Eng 4(3):215–227
Leone M, Centonze G, Colonna D, Micelli F, Aiello MA (2018) Fiber-reinforced concrete with low content of recycled steel fiber: shear behaviour. Constr Build Mater 161:141–155
Li X, Wang Z, Zhang J (2017) Stability of roof structure and its control in steeply inclined coal seams. Int J Min Sci Technol 27(2):359–364
Lin H, Cao P, Fang J, Liu Q (2012) Confirmation on reasonable timbering time for tunnel in rheological cases of III-rock mass. Disaster Adv 5(4):220–225
Liu Y, Wang Y, Ma H (2011) Research on tomography by using seismic reflection wave in laneway. Procedia Eng 26:2360–2368
Lu TK, Liu YZ, Xu FS (2007) Deformation and failure of stratified weak roof strata of longwall roadway. J Univ Sci Technol Beijing Miner Metall Mater 14(5):387–394
Lu YL, Wang LG, Zhang B (2011) An experimental study of a yielding support for roadways constructed in deep broken soft rock under high stress. Min Sci Technol (China) 21(6):839–844
Manica M, Gens A, Vaunat J, Ruiz DF (2017) A time-dependent anisotropic model for argillaceous rocks. Application to an underground excavation in Callovo-Oxfordian claystone. Comput Geotech 85:341–350
Niedbalski Z, Małkowski P, Majcherczyk T (2018) Application of the NATM method in the road tunneling works in difficult geological conditions—the Carpathian flysch. Tunn Undergr Space Technol 74:41–59
Paglia C, Wombacher F, Böhni H (2001) The influence of alkali-free and alkaline shotcrete accelerators within cement systems: I. characterization of the setting behavior. Cem Concr Res 31(6):913–918
Paglia CSB, Wombacher FJ, Bohni HK (2004) Influence of alkali-free and alkaline shotcrete accelerators within cement systems: hydration, microstructure, and strength development. ACI Mater J 101(5):353–357
Pellet F, Roosefid M, Deleruyelle F (2009) On the 3D numerical modelling of the time-dependent development of the damage zone around underground galleries during and after excavation. Tunn Undergr Space Technol 24(6):665–674
Saw HA, Villaescusa E, Windsor CR, Thompson AG (2017) Surface support capabilities of freshly sprayed fibre reinforced concrete and safe re-entry time for underground excavations. Tunn Undergr Space Technol 64:34–42
Shang JL, Luo XW, Gao F, Hu JH, Zhou KP (2012) Advanced predication of geological anomalous body ahead of laneway using seismic tomography technique. Procedia Eng 43:324–330
Souley M, Armand G, Su K, Ghoreychi M (2011) Modeling the viscoplastic and damage behavior in deep argillaceous rocks. Phys Chem Earth A/B/C 36(17):1949–1959
Sounthararajan VM (2013) Toughness characterization of steel fibre reinforced concrete—–a review on various international standards. Ceram Int 38(75):5089–5093
Wang C (2000) The optimal support intensity for coal mine roadway tunnels in soft rocks. Int J Rock Mech Min Sci 37(7):1155–1160
Wang C, Wang Y, Lu S (2000) Deformational behaviour of roadways in soft rocks in underground coal mines and principles for stability control. Int J Rock Mech Min Sci 37(6):937–946
Wang LG, Lu YL (2011) Ground stress and its impact on the stability of the surrounding rock in the Lüliang mining area. Min Sci Technol (China) 21(5):625–630
Wang FT, Zhang C, Wei SF, Zhang XG, Guo SH (2016) Whole section anchor-grouting reinforcement technology and its application in underground roadways with loose and fractured surrounding rock. Tunn Undergr Sp Tech 51:133-143
Yang JM, Kim JK, Yoo DY (2017) Performance of shotcrete containing amorphous fibers for tunnel applications. Tunn Undergr Space Technol 64:85–94
Yan S, Bai JB, Li WF, Chen JG, Li L (2012) Deformation mechanism and stability control of roadway along a fault subjected to mining. Int J Min Sci Technol 22(4):559–565
Yoo DY, Banthia N (2016) Mechanical properties of ultra-high-performance fiber-reinforced concrete: a review. Cem Concr Compos 73:267–280
Acknowledgements
The study was funded from Project (51404179, 51704168, 51804236, 51804235) supported by National Natural Science Foundation of China. The authors wish to acknowledge the financial support of the agency.
Author information
Authors and Affiliations
Corresponding authors
Rights and permissions
About this article
Cite this article
Zhang, C., Pu, C., Cao, R. et al. The stability and roof-support optimization of roadways passing through unfavorable geological bodies using advanced detection and monitoring methods, among others, in the Sanmenxia Bauxite Mine in China’s Henan Province. Bull Eng Geol Environ 78, 5087–5099 (2019). https://doi.org/10.1007/s10064-018-01439-1
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10064-018-01439-1