Abstract
Superelastic NiTi was subjected to simultaneous neutron diffraction and uniaxial compressive cycling between 10 and 980 MPa. The objective was anin-situ investigation of the evolution of the stress-induced, reversible transformation between austenite and martensite, to determine the cause of the changes in the macroscopic stress-strain response with cycling. Rietveld refinement was used to analyze the neutron spectra and quantify the phase fraction, texture, and elastic strain. The average phase strain in the mechanically loaded austenite (at a given stress) remained unaltered during the 100 load-unload cycles. However, differences in both the volume fraction and texture of austenite and martensite were noted as cycling progressed, suggesting that these factors are responsible for the changes in the macroscopic stress-strain response of NiTi with mechanical cycling.
Similar content being viewed by others
References
Shape Memory Alloys, H. Funakubo, ed, Gordon and Breach, New York, NY, 1987.
Engineering Aspects of Shape Memory Alloys, T.W. Duerig, K.N. Melton, D. Stoeckel, and C.M. Wayman, eds., Butterworth-Heinemann, London, 1990.
Shape Memory Materials, K. Otsuka and C.M. Wayman, eds., Cambridge University Press, Cambridge, United Kingdom, 1998.
K.N. Melton and O. Mercier:Acta Metall., 1979, vol. 27, pp. 137–44.
S. Miyazaki, T. Imai, K. Otsuka, and Y. Suzuki:Scripta Metall., 1981, vol. 15, pp. 853–56.
S. Miyazaki, T. Imai, Y. Igo, and K. Otsuka:Metall. Trans. A, 1986, vol. 17A, pp. 115–20.
M. Kawaguchi, Y. Ohashi, and H. Tobushi:JSME Int. J., 1991, vol. 34, pp. 76–82.
H. Tobushi, H. Iwanaga, K. Tanaka, T. Hori, and T. Sawada:JSME Int. J., 1992, vol. 35, pp. 271–77.
N. Hagemeister, L.H. Yahia, C. Armand, and T. Lours:1st Int. Conf. on Shape Memory and Superelastic Technologies, Pacific Grove, CA, 1994, pp. 395–400.
B. Strnadel, S. Ohashi, H. Ohtsuka, S. Miyazaki, and T. Ishihara:Mater. Sci. Eng. A, 1995, vol. A203, pp. 187–96.
B. Strnadel, S. Ohashi, H. Ohtsuka, T. Ishihara, and S. Miyazaki:Mater. Sci. Eng. A, 1995, vol. A202, pp. 148–56.
R. Vaidyanathan, M.A.M. Bourke, and D.C. Dunand:J. Appl. Phys., 1999, vol. 86, pp. 3020–29.
M.A.M. Bourke, R. Vaidyanathan, and D.C. Dunand:Appl. Phys. Lett., 1996, vol. 69, pp. 2477–79.
Y.C. Shu and K. Bhattacharya:Acta Mater., 1998, vol. 46, pp. 5457–73.
K. Gall, H. Sehitoglu, Y.I. Chumlyakov, and I.V. Kireeva:Acta Mater., 1999, vol. 47, pp. 1203–17.
M.A.M. Bourke, J.A. Goldstone, and T.M. Holden: inMeasurement of Residual and Applied Stress Using Neutron Diffraction, M.T. Hutchings and A.D. Krawitz, eds., Kluwer Academic, Dordrecht, Netherlands, 1992, pp. 369–82.
N. Shi, M.A.M. Bourke, J.A. Roberts, and J.E. Allison:Metall. Mater. Trans. A, 1997, vol. 28A, pp. 2741–53.
R. Vaidyanathan: Ph.D. Thesis, massachusetts Institute of Technology, Cambridge, MA, 1999.
R. Vaidyanathan, M.A.M. Bourke, and D.C. Dunand:Acta Mater., 1999, vol. 47, pp. 3353–66.
R. Vaidyanathan, M.A.M. Bourke, and D.C. Dunand:Mater. Sci. Eng. A, 1999, vols A273-A275, pp. 404–09.
H.M. Rietveld:J. Appl. Cryst., 1969, vol. 2, pp. 65–71.
A.C. Larson and R.B. VonDreele: Report No. LAUR 8-748, Los Alamos National Laboratory, Los Alamos, NM, 1986.
R.B. VonDreele:J. Appl. Cryst., 1997, vol. 30, pp. 517–25.
H.J. Bunge:Texture Analysis in Materials Science, Butterworth-Heinemann, London, 1982.
K.L. Fukami-Ushiro and D.C. Dunand:Metall. Mater. Trans. A, 1996, vol. 27A, pp. 183–91.
E.F. Sturcken and J.W. Croach:Trans. TMS-AIME, 1963, vol. 227, pp. 934–40.
Y. Liu, I. Houver, H. Xiang, L. Bataillard, and S. Miyazaki:Metall. Mater. Trans. A, 1999, vol. 30A, pp. 1275–82.
T. Saburi and S. Nenno: inSolid-Solid Phase Transformations, H.I. Aaronson, ed., TMS-AIME, Warrendale, PA, 1981, pp. 1455–79.
D.C. Dunand, D. Mari, M.A.M. Bourke, and J.A. Roberts:Metall. Mater. Trans. A, 1996, vol. 27A, pp. 2820–36.
R. Plietsch and K. Ehrlich:Acta Mater., 1997, vol. 45, pp. 2417–24.
M.R. Daymond, M.A.M. Bourke, and R.B.V. Dreele:J. Appl. Phys., 1997, vol. 82, pp. 1554–62.
R. Vaidyanathan, U. Ramamurty, and D.C. Dunand:Mater. Sci Eng. A, 2000, vol. A289 (1–2), pp. 208–16.
Author information
Authors and Affiliations
Additional information
R. VAIDYANATHAN, formerly Postdoctoral Associate, Laboratory for Experimental and Computational Micromechanics, Massachusetts Institute of Technology
Rights and permissions
About this article
Cite this article
Vaidyanathan, R., Bourke, M.A.M. & Dunand, D.C. Texture, strain, and phase-fraction measurements during mechanical cycling in superelastic NiTi. Metall Mater Trans A 32, 777–786 (2001). https://doi.org/10.1007/s11661-001-1012-y
Received:
Issue Date:
DOI: https://doi.org/10.1007/s11661-001-1012-y