Skip to main content
Log in

Study on the difference of pore structure of anthracite under different particle sizes using low-temperature nitrogen adsorption method

  • Research Article
  • Published:
Environmental Science and Pollution Research Aims and scope Submit manuscript

Abstract

The low-temperature nitrogen adsorption test was used to study anthracite from Jiulishan coal mine with different particle size ranges of 60–80 mesh, 150–200 mesh, and > 200 mesh. The adsorption isotherm, adsorption capacity, pore volume, pore specific surface area, and average pore diameter of coal samples were analyzed by BET and DFT models in order to study the influence of particle size on the pore structure of anthracite and determine the optimal range of particle size for low-temperature nitrogen adsorption test. The results indicate that the particle size plays a significant effect on the pore structure of anthracite and the adsorption capacity of soft coal is less affected by particle size, while hard coal is substantially affected by particle size. The adsorption capacity of hard coal with particle size of > 200 mesh is increased by 7 times when compared with the particle size of 60–80 mesh, indicating that the gas molecular mobility hindrance decline and pore connectivity improves with the decrease of particle size. The average pore diameter of hard coal decreases continuously from 3.1424 to 2.854 nm, while that of soft coal expands from 2.8947 to 3.2515 nm and then to 3.0362 nm with the decrease of particle size. The effects of particle size on the pore surface area of soft and hard coal are concentrated within the < 10 nm pore aperture. Effect of particle size on hard coal pore volume is mainly focused in the pore size < 10 nm, whereas that of soft coal is primarily concentrated in the pore with aperture ranges of 2–100 nm. When the particle sizes varies from 60–80 mesh to 150–200 mesh, the collapse of large pore of hard coal appears better than that of closed pore. When the particle size of hard coal reaches > 200 mesh, the collapse of closed pores and the damage to small pores are stronger than the collapse of large pores. The fractal dimensions with relative pressure of 0–0.20 and 0.20–0.995 are defined as D1 and D2, respectively, and when the fractal dimension D1 increases, the surface roughness and structural complexity of coal samples increase with the decrease of anthracite particle size, while the fractal dimension D2 shows the opposite trend, which indicates that anthracite of smaller particle size possess higher adsorption capacity. Therefore, 150–200 mesh is recommended as the preferred anthracite particle size in low-temperature nitrogen adsorption test.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Fig. 10
Fig. 11

Similar content being viewed by others

Data availability

The data used are available on reasonable request.

References

Download references

Funding

This research was supported by the National Natural Science Foundation of China (No. 51704100, No. 52074107, No.52074105, No.51874122); Postdoctoral Research Foundation of Henan Province (First-class financial support); Henan Provincial Key Laboratory of Gas Geology and Gas Control—Open Project of the State Key Laboratory Cultivation Base jointly built by the province and the ministry (No. WS2018B13, No. WS2020B14); Doctoral Fund of Henan Polytechnic University (No. B2016-004); Fundamental and Frontier Technology Research Project of Henan Province (No. 162300410038); and Key Scientific Research Project of Higher Education Institutions of Henan Provincial Department of Education (No. 15A440007).

Author information

Authors and Affiliations

Authors

Contributions

Lingling Qi: Formal analysis and writing—original draft. Xiaoqing Zhou: Data processing and analysis. Xinshan Peng: Crushed coal samples and performed experimental measurement. Xiangjun Chen: Formal analysis and supervision. Zhaofeng Wang: Supervision. Fenghua An: Data curation.

Corresponding author

Correspondence to Lingling Qi.

Ethics declarations

Ethics approval

We declare that all ethical guidelines for authors have been followed by all authors.

Consent to participate

All authors have given their consent to participate in submitting this manuscript to this journal.

Consent for publication

All authors have given their consent to publish this paper in this journal.

Competing interests

The authors declare no competing interests.

Additional information

Responsible Editor: Shimin Liu

Publisher's note

Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.

Rights and permissions

Springer Nature or its licensor holds exclusive rights to this article under a publishing agreement with the author(s) or other rightsholder(s); author self-archiving of the accepted manuscript version of this article is solely governed by the terms of such publishing agreement and applicable law.

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Qi, L., Zhou, X., Peng, X. et al. Study on the difference of pore structure of anthracite under different particle sizes using low-temperature nitrogen adsorption method. Environ Sci Pollut Res 30, 5216–5230 (2023). https://doi.org/10.1007/s11356-022-22533-8

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s11356-022-22533-8

Keywords

Navigation