Elsevier

Acta Metallurgica

Volume 37, Issue 9, September 1989, Pages 2551-2558
Acta Metallurgica

The stability of the oxide dispersion in INCONEL alloy MA6000

https://doi.org/10.1016/0001-6160(89)90053-9Get rights and content

Abstract

Analytical transmission electron microscopy has been used to examine the stability of the oxide dispersion in the mechanically alloyed, nickel-based, dispersion strengthened superalloy, INCONEL alloy MA6000. Hot rolling consolidated powder does not cause any change to the dispersoid but zone annealing, however, induces a number of changes to the four mixed Y-A1 oxide phases which constitute the dispersoid: the yttrium aluminium monoclinic (Y4Al2O9) phase disappears; the yttrium aluminium garnet (Y3Al5O12) and yttrium aluminium perovskite (YAlO3) phases rotate in the host crystals and orientation relationships arise between these oxides and the matrix and the yttrium aluminium hexagonal (YAlO3) phase becomes dominant, constituting approximately 90% of the dispersoid. On subsequent heat treatment at 850°C, no detectable growth of the oxides occurred, while some growth did occur after 1000 h at 1100°C. This Ostwald ripening occurred by an interface-controlled mechanism.

Résumé

On a utilisé la microscopic électronique analytique en transmission pour étudier la stabilité de la dispersion des oxydes dans le superalliage INCONEL MA 6000 à base de nickel, allié mécaniquement et durci par dispersion. Le laminage à chaud de la poudre consolidée ne cause aucune modification du dispersoïde, alors que le recuit par zones, lui, provoque de nombreuses modifications des quatre phases de l'oxyde mixte d'yttrium et d'aluminium qui constituent le dispersoïde: la phase monoclinique (Y4Al2O9) disparaît; les phases grenat (Y3 Al5O12) et perovskite (YAlO3) subissent une rotation dans les cristaux qui les contiennent, et il en résulte des relations d'orientation entre ces oxydes et la matrice; enfin, la phase hexagonale (YAlO3) finit par dominer, en constituant environ 90% du dispersoïde. Lors d'un traitement thermique ultérieur à 850°C, on ne détecte aucune croissance des oxydes, ce qui n'est pas le cas après 1000 h de traitement à 1100°C. Ce mûrissement d'Ostwald est dû à un mécanisme contrôlé par l'interface.

Zusammenfassung

Die Stabilität der Oxiddispersion wurde in der mechanisch legierten dispersionsgehärteten Legierung INCONEL MA 6000 mittels analytischer Durchstrahlungselektronenmikroskopie untersucht. Heiβwalzen der verdichteten Pulver ändert nichts an der Dispersion, Zonenausheilen jedoch führt zu einer Reihe von Änderungen in den vier gemischten Y-Al-Phasen der Dispersion: Die monokline Yttrium-Aluminium-Phase (Y4Al2O9) verschwindet; die Phasen Yttrium-Aluminium-Granat (Y3Al5O12) und Yttrium-Aluminium-Perovskit (YAlO3) rotieren im Wirtskristall, es bilden sich Orientierungsbeziehungen zwischen diesen Oxiden und dem Wirtsgitter aus, wobei die hexagonale Yttrium-Aluminium-Phase (YAlO3) dominierend wird und bis zu 90% der Dispersion erreicht. Bei einer nachfolgenden Wärmebehandlung bei 850°C wachsen die Oxide nicht merklich, wohingegen ein gewisses Wachstum nach 1000h bei 1100°C zu finden ist. Diese Ostwald-Reifung läuft über einen grenzflächengesteuerten Mechanismus ab.

References (28)

  • M.P. Anderson et al.

    Mater. Sci. Engng

    (1983)
  • P.W. Voorhees et al.

    Acta metall.

    (1987)
  • P.W. Voorhees et al.

    Acta metall.

    (1988)
  • J.S. Benjamin et al.

    High Temperatures-High Pressures

    (1974)
  • R.E. Lawn et al.

    Powder Metals

    (1976)
  • F.G. Wilson et al.

    Metall Trans. A

    (1978)
  • J.J. Fischer et al.
  • M. Raghavan et al.
  • M. Raghavan et al.

    Metall. Trans. A

    (1982)
  • S.K. Kang et al.

    Metall. Trans. A

    (1985)
  • G.B. Schaffer
  • C.J. Burton et al.

    Metall. Trans. A

    (1979)
  • V.C. Nardone et al.

    Metall. Trans. A

    (1983)
  • M.F. Ashby

    Phil. Mag.

    (1966)
  • Cited by (0)

    INCONEL is a registered trademark of the Inco Family of Companies.

    View full text