Chaos control of the power system via sliding mode based on fuzzy supervisor

The purpose of this paper is to address the problem of control in a typical chaotic power system. Chaotic oscillations cannot only extremely endanger the stabilization of the power system but they can also not be controlled by adding the traditional controllers. So, the sliding mode control based on a fuzzy supervisor can sufficiently ensure perfect tracking and controlling in the presence of uncertainties. Closed-loop stability is proved using the Lyapunov stability theory. The simulation results show the effectiveness of the proposed method in damping chaotic oscillations of the power system, eliminating control signal chattering and also show less control effort in comparison with the methods considered in previous literatures.

The sliding mode control based on a fuzzy supervisor can sufficiently ensure perfect tracking and controlling in the presence of uncertainties. Closed-loop stability is proved using the Lyapunov stability theory.

Closed-loop stability is proved using the Lyapunov stability theory. The simulation results show the effectiveness of the proposed method in damping chaotic oscillations of power system, eliminating control signal chattering and also less control effort in comparison with the methods considered in previous literatures.

Main contributions of the paper are as follows: the chaotic behavior of power systems with two uncertainty parameters and tracking reference signal for the control of generator angle and the controller signal are discussed; designing sliding mode control based on a fuzzy supervisor in order to practically implement for the first time; while the generator speed is constant, the proposed controller will enable the power system to go in any desired trajectory for generator angle at first time; stability of the closed-loop sliding mode control based on the fuzzy supervisor system is proved using the Lyapunov stability theory; simulation of the proposed controller shows that the chattering is low control signal.