Type I mid-infrared MQW lasers using AlInAsSb barriers and InAsSb wells

Leslie G. Vaughn; L. Ralph Dawson; Edwin A. Pease; Luke F. Lester; Huifang Xu; Yingbing Jiang; Alan L. Gray

doi:10.1117/12.606226

28 April 2005 Type I mid-infrared MQW lasers using AlInAsSb barriers and InAsSb wells

Leslie G. Vaughn, L. Ralph Dawson, Edwin A. Pease, Luke F. Lester, Huifang Xu, Yingbing Jiang, Alan L. Gray

Proceedings Volume 5722, Physics and Simulation of Optoelectronic Devices XIII; (2005) https://doi.org/10.1117/12.606226
Event: Integrated Optoelectronic Devices 2005, 2005, San Jose, California, United States

Abstract

For many years, mid-infrared (2-5μm) semiconductor lasers operating at or near room temperature have been sought for use in LADAR, gas sensing, and spectroscopy. Smaller bandgap materials necessary for this range are more susceptible to non-radiative Auger recombination. Further, as laser structures become more complicated, like quantum cascade intersubband and interband lasers, Shockley-Read-Hall losses increase. The simplest structure is Type-I multiple quantum well (MQW), but few QW III-V heterojunction material systems capable of 2-5μm emission have a Type-I offset. One such system with InAsSb wells and AlInAsSb barriers has been unable to exceed 175K under CW operation partially due to poor carrier confinement associated with small valence band offsets. This paper describes the growth and performance of AlInAsSb/InAsSb lasers using a 0.3 mole fraction of Al in the Group III elements. Increased Al content enhances the valence and conduction band offsets, but the AlInAsSb alloy exhibits a miscibility gap above 0.06 Al mole fraction, so a digital alloy technique was used to grow high quality 0.3-2μm thick quaternary films. As Al mole fraction in the barriers was increased from 0.20 to 0.30 an 80-fold increase in photoluminescence (PL) was observed. The corresponding lasers were grown and tested demonstrating lasing at 3.9μm and 50K. Theoretical studies suggest that adding Ga to the barriers, forming an AlGaInAsSb quinary alloy, results in band structures more favorable towards minimizing Auger effects and realizing Type I offset behavior over a wider range of alloy compositions. PL structures were grown and tested, again using a digital alloy technique for the quinary alloy. Preliminary results show promise.

Citation Download Citation

Leslie G. Vaughn, L. Ralph Dawson, Edwin A. Pease, Luke F. Lester, Huifang Xu, Yingbing Jiang, and Alan L. Gray "Type I mid-infrared MQW lasers using AlInAsSb barriers and InAsSb wells", Proc. SPIE 5722, Physics and Simulation of Optoelectronic Devices XIII, (28 April 2005); https://doi.org/10.1117/12.606226

ACCESS THE FULL ARTICLE

INSTITUTIONAL
Select your institution to access the SPIE Digital Library.

SELECT YOUR INSTITUTION

PERSONAL
Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.

PERSONAL SIGN IN

No SPIE Account? Create one

PURCHASE THIS CONTENT

SUBSCRIBE TO DIGITAL LIBRARY

50 downloads per 1-year subscription

Members: $195

Non-members: $335 ADD TO CART

25 downloads per 1 - year subscription

Members: $145

Non-members: $250 ADD TO CART

PURCHASE SINGLE ARTICLE

Includes PDF, HTML & Video, when available