1 December 1975 Design of Highly Stable Optical Support Structure
Michael H. Krim
Author Affiliations +
Abstract
As spaceborne optical systems increase in diameter to achieve improved resolution, the stability requirements imposed on structures approach values which were unthinkable only several years ago. To achieve the capabilities of these apertures optical path errors must not exceed a specific fraction of the wavelength of light, and this fraction, typically x/20 rms in the focal plane, is independent of system size. Thus, from a percentage error basis, large optical support structures represent a far more formidable development task than do smaller systems. The Large Space Telescope (LST) sponsored by MSFC/NASA is a case in point. The Optical Telescope Assembly (OTA) is shown (Fig. 1) installed in the LST spacecraft. The vertex-to-vertex spacing of the primary and secondary mirror is 193 inches. To achieve satisfactory optical performance, this spacing must be maintained constant to a precision of -±11.1 for observation periods up to 10 hours. During this time it may be necessary to alter the spacecraft attitude with respect to the sun, which would change the temperature levels and gradients within the structures. It is believed that by exploiting the use of graphite-epoxy in a novel manner, the stringent alignment require-ments can be satisfied with a nominally passive structure.
Michael H. Krim "Design of Highly Stable Optical Support Structure," Optical Engineering 14(6), 146552 (1 December 1975). https://doi.org/10.1117/12.7971792
Published: 1 December 1975
Lens.org Logo
CITATIONS
Cited by 8 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Structural design

Space operations

Mirrors

Optical telescopes

Space telescopes

Sun

Temperature metrology

RELATED CONTENT


Back to Top