Paper
18 May 1987 Recent Results in Precision Measurements of Edges, Angles, Areas and Perimeters
O.Robert Mitchell, Edward P. Lyvers, Kirk A. Dunkelberger, Mark L. Akey
Author Affiliations +
Proceedings Volume 0730, Automated Inspection and Measurement; (1987) https://doi.org/10.1117/12.937867
Event: Cambridge Symposium_Intelligent Robotics Systems, 1986, Cambridge, MA, United States
Abstract
This paper presents recent results in precision measurements using computer vision. An edge operator based on two-dimensional spatial moments is used. This operator can locate correctly modeled edges to hundredths of a pixel. This accuracy is unaffected by additive or multiplicative changes to the data values. The precision is achieved by correcting for many of the deterministic errors caused by non-ideal edge profiles using a look-up table to correct the original estimates of edge orientation and location. This table is generated using a synthesized edge which is located at various subpixel locations and various orientations. The edge locator is then used to estimate area and perimeter of imaged objects. Area and perimeter are also measured using averages of estimates from binary images generated by thresholding at many gray values. This method of threshold decomposition is compared to the edge detection methods. The application of these techniques to measurement of imaged machined metal parts is also presented.
© (1987) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
O.Robert Mitchell, Edward P. Lyvers, Kirk A. Dunkelberger, and Mark L. Akey "Recent Results in Precision Measurements of Edges, Angles, Areas and Perimeters", Proc. SPIE 0730, Automated Inspection and Measurement, (18 May 1987); https://doi.org/10.1117/12.937867
Lens.org Logo
CITATIONS
Cited by 12 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Error analysis

Binary data

Inspection

Data modeling

Edge detection

Precision measurement

Sensors

Back to Top