[1]
J.L. Huang, X.X. Miu, S.M. Luo, L.F. Chen, A research for influence of the gear pressure angle on tooth surface contact intensity, Machinery Design & Manufacture. 11 (2006) 25-26.
Google Scholar
[2]
Mechanical Design Graphic Manual Editorial board, Mechanical Design Graphic Manual, third ed., China Machine, Beijing, 2004.
Google Scholar
[3]
Y.J. Zhao, K. Dong, Mechanical performance analysis of spur gear with 28 DEG pressure angle, Journal of Mechanical Transmission. 1 (2004) 52-53.
Google Scholar
[4]
Y.C. Zhang, A research for influence of the gear pressure angle on mean flash temperature on tooth surface, Mechanical Transmission. 2 (1994) 31-32.
Google Scholar
[5]
L.X. Zhu, K. Zhong, Analysis of Load Capacity of Gears, Higher Education Press, Beijing, 1992.
Google Scholar
[6]
H. Sun, Chen Zuomo, Principle of Mechanics, Higher Education Press, Beijing, 2001.
Google Scholar
[7]
I. I. Semenchenko, T.L. Dihua, H. Mingtao, Gear Cutter, first ed., Mechanical Industry, Beijing, 1958.
Google Scholar
[8]
J.L. He, W. Zhang, H.B. Zhang, et al., Study on minimum teeth without undercutting of standard involute gears. Advanced Material Research vols. 199-200(2011)329-336.
DOI: 10.4028/www.scientific.net/amr.199-200.329
Google Scholar
[9]
N.H. Peng, Q.E. Chen, J.L. He, et al., The analysis of undercut gear model based on MATLAB, Modern Design and Advanced Manufacturing Technology. 9 (2007) 29-33.
Google Scholar
[10]
J. Liu, B. Luo, Analysis on the minimum number of teeth of standard involute gear, Manufacture Information Engineering of China, 2( 2003) 110-111.
Google Scholar
[11]
Z.Q. Yang, Principle of Mechanics, Beijing Institute of Technology press, Beijing, 1995.
Google Scholar
[12]
Y. Gao, J.N. He, W. Zhang, Q. Li, Study on Minimum Teeth without Undercutting of the Spur Involute Gears with 22.5° and 25° Pressure Angle Based on VB, International Conference on Computer Science and Electronics Engineering, vols. 1 (2012) 84-88.
DOI: 10.1109/iccsee.2012.72
Google Scholar
[13]
J.N. He, Y. Gao, H.B. Zhang, et al., Study on minimum teeth without undercutting of the stub tooth involute gears based on VB, Inter. Conf. Computer Sci. Electro. Eng. vols. 1 (2012) 80-83.
DOI: 10.1109/iccsee.2012.396
Google Scholar
