Synthesis and Properties of Bulk Amorphous/Nanocrystalline Aluminum Alloy Composites

Si Joon Noh; Taek Kyun Jung; Dong  Suk Lee; Mok Soon Kim; Sung Yi

doi:10.4028/www.scientific.net/MSF.510-511.830

Paper Titles

Comparison of Hydroxyapatite Synthesized under Different Conditions
p.814

Densification Mechanism of Fine Ni-20Cr Powder during Pulsed Electric Current Sintering
p.818

Influence of Two-Step Sintering on Transparency of High Purity Alumina
p.822

Radio Frequency Interference Characteristics of Plate-Like Soft Magnetic Powders-Polymer Composites
p.826

Synthesis and Properties of Bulk Amorphous/Nanocrystalline Aluminum Alloy Composites
p.830

Design for Environment (DfE) of Ultralight Aluminum Camshaft Development
p.834

Tribological Analysis of Al₂O₃/TiO₂/ZrO₂ Nanocomposites as an Alternative for THR Materials
p.838

The Characteristic of the La₃Ga₅SiO₁₄ Single Crystal Grown by Vertical Bridgman Method in Ar Atmosphere
p.842

Preparation and Characterization of a New Type of Sr-Contained Hydroxyapatite Bone Cement
p.846

HomeMaterials Science ForumMaterials Science Forum Vols. 510-511Synthesis and Properties of Bulk...

Synthesis and Properties of Bulk Amorphous/Nanocrystalline Aluminum Alloy Composites

Abstract:

The rod-shaped bulk composites consisting of Al-10Ni-6Ce and Al-4Fe-0.6Mo-1.1V- 0.3Zr alloy (mixing ratio; 0.7:0.3, 0.5:0.5 and 0.3:0.7) and corresponding monolithic alloys were produced to a full density via powder forging process. The process involved pre-compaction of rapidly solidified alloy powders and subsequent isothermal forging at 673K. The forged Al-10Ni- 6Ce alloy exhibited nano-scaled crystalline particles, such as fcc-Al, Al3Ni, Al4Ce and Al11Ce3 phase, coexisting with an amorphous phase. In the case of the forged Al-4Fe-0.6Mo-1.1V-0.3Zr alloy, an equiaxed grain structure was observed to exist with uniformly distributed nano-scaled Al- Fe based intermetallics. The monolithic Al-10Ni-6Ce alloy had a considerably high maximum compressive strength (MCS) of 1.35 GPa without showing any compressive plastic strain (CPS). In contrast, the monolithic Al-4Fe-0.6Mo-1.1V-0.3Zr alloy possessed noticeably high CPS of 25% with the MCS of 0.71GPa. The composites acquired the CPS varying from 1 to 5.8 % and the MCS from 1.26 to 0.74 GPa, with increment of the volume fraction of Al-4Fe-0.6Mo-1.1V-0.3Zr alloy from 0.3 to 0.7.