This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Advanced Approaches for Heat Transfer Calculations
Annotation ability available
Sector:
Language:
English
Abstract
For the purpose of determining the heat transfer extensive experimental investigations have been carried out. Since the generally usual method of heat balance can not supply sufficiently detailed and appropriate results, three measurements procedures have been improved in such a way that the required degree of accuracy can be achieved:Surface temperature method heat flux probe application and combustion chamber pressure measurement. The results obtained from these experiments form the basis for an uncomplicated, yet precise method of heat transfer calculation. Comparisons between measured and calculated heat flux show sufficient concurrence.
Recommended Content
Authors
Citation
Hohenberg, G., "Advanced Approaches for Heat Transfer Calculations," SAE Technical Paper 790825, 1979, https://doi.org/10.4271/790825.Also In
References
- Eichelberg G. “Some new investigations on old combustion-engine problems,” Engineering 148 463 466 547 550 603 605 682 686 1939
- Hug K. “Messung und Berechnung von Kolbentemperaturen in Dieselmotoren,” 1936
- Salzmann F. “Wärmefluß durch Kolben und Kolbenring im Dieselmotor,” 1932
- Kind R. “Messung des instationären Wärmeüberganges in einem Zweitakt-Dieselmotor hoher Drehzahl,” 1962
- Shiling K. “Beitrag zur experimentellen Bestimmung des instationären, gasseitigen Wärmeübergangskoeffizienten in Dieselmotoren,” 1976
- Hohenberg G. Hardenberg H. “A new method for the analysis of the air swirl in the combustion chamber of diesel engines,” CIMAC Wien 1979
- Horvatin M. Hussmann A. W. “Messung von Luftbewegungen im Zylinder von Verbrennungsmotoren,” FISITA 1968
- Große W. “Messung des Strömungsfeldes in einem Dieselmotor mit starker Luftdrehung,” 1974
- Witze P. O. “Measurements of the spatial distribution and engine speed dependence of turbulent air motion in an I.C. engine,” SAE-Paper 770220 SAE-Congress Detroit Febr. March 77
- Jagadusan T. R. Murthy B. S. “Study of air motion in a compression ignition engine cylinder,” SAE-Paper 770406 SAE-Congress Detroit February March 1977
- Pflaum W. Mollenhauer K. “Wärmeübergang in der Verbrennungskraftmaschine,” Springer-Verlag Wien 1977
- Strohmer E. “Wärmeübergang im Verbrennungsmotor,” 1978
- Woschni G. “Die Berechnung der Wandverluste und der thermischen Belastung der Bauteile von Dieselmotoren,” MTZ 31 12 491 499 1970
- Hampel R. Kurr D. Schefenacker H. “Elektronisches Meßsystem zur digitalen Erfassung und Auswertung von Indikatordiagrammen,” MTZ 36 1975
- Hohenberg G. “EDV-unterstützte Auswertung von Verbrennungsuntersuchungen,” February 1977
- Dounaud A. Fyzat P. “DIGITAP - an on line acquisition on processing system for instantaneous engine data-applications,” SAE-Paper 770218 SAE-Congress Detroit February March 1977
- Hohenberg G. “Definition und Eigenschaften des thermodynamischen Verlustwinkels von Kolbenmaschinen,” Automobil-Industrie April 1976
- Zapf H. “Beitrag zur Untersuchung des Wärmeüberganges während des Ladungswechsels im Viertakt-Dieselmotor,” MTZ 30 461 465 1969
- Sitkei G. Ramanaiah G. “A rational approach for calculation of heat transfer in diesel engines,” SAE-Paper 720027 165 174 1972
- Annand W. J. D. “Heat transfer in the cylinders of reciprocating internal combustion engines,” Proc. Inst. Mech. Engrs. 177 973 990 1963
- Pflaum W. “Heat transfer in internal combustion engines,” La Termotecnica 235 246 April 1963
- Dent J. C. Suliaman S. J. “Convective and radiative heat transfer in a high swirl direct injection diesel engine,” SAE-Paper 770407 SAE-Congress Detroit February March 1977